CRUSHING LINE :LET HIM HELP YOU MAKE MONEY

FOR IMMEDIATE RELEASE
(Free-Press-Release.com) February 12, 2012 --

The preparation for the equipment operation and check 1, lubrication part in check whether there is enough fuel tank lubricating oil,Mobile impact crusher whether to comply with oil, filter oil device is not clean. 2, a test drive oil pump, check the oil pump and pipeline for oil leakage failure. 3 and oil pressure is in 0.8-1.Rotary dryer5 kg/cm2 between. 4, check back to the oil is not clear, duct is not stable. 5, and body are screws and base frame anchor in body interface is not a loose screw phenomenon. 6, the drive shaft, each screws and pulley, the healthy is loose. 7,Hydraulic cone crusher crusher cavity for materials, such as a need to clear can drive. 8, the body easy wear parts (such as broken cone lining board and a body of lining board) if there is serious wear or chip. 9, check whether funnel blocked or severe worn. 10,Cone crusher electrical part of the oil in the handwheel rheostat immersion is zero. 11,Artificial sand washer check the motor carbon brush contact. 12, check the distribution box, operating mechanism is not agile. 13, check the ammeter pointer is in zero. Four,Cement plant the operation method 1, equipment operation method (1) before operation according to check the content must be checked item by item. (2) shall first start the oil pump, back to normal rear can start motor oil. (3) should be very careful when starting motor and the noise of the crusher, if there are any complications should immediately stop working. (4) equipment normal operation after the start to mine. (5) stop working to stop to mine, when broken cavity ore to no parking. (6) to stop the oil pump oil. 2, machine drive operation order: (1) the first check the oil leaching rheostat is in zero,Rock crushers short circuit breaker is on. (2) press the start button. (3) will be baptized rheostat handwheel oil slowly to the starting position of transhipment, until the motor reaching the rated speed. (4) will be short circuit breaker closed. (5) observation ammeter instructions are normal. (6) motor shall not frequent start, general continuous start shall not be more than three times. 3, parking operation order: (1) shall be first stop before parking to mine, when crusher cavity ore from all, then stop crusher. (2) the operation personnel press stop button. (3) will be baptized rheostat handwheel turned back to oil zero, open circuit breaker switch. (4) no notice of power failures or carrying load after parking, beard crusher cavity between ore take out, so that after the call to drive.


Artificial sand maker：www.hxjqcrusher.com/Sand-maker.html
Cone crusher supplier：www.hxjqcrusher.com/Cone-crusher.html
Cone crushers：www.china-crusher.com/cone-crusher5.html