How to do the maintenance work on crusher –twinklele12

FOR IMMEDIATE RELEASE
(Free-Press-Release.com) January 3, 2012 -- Maintenance of Crusher equipment is a complex and painstaking work. Not only to keeping the equipment clean, properly lubricated, and the system for the implementation of technical operations and daily inspection of all parts ministries need to strengthen management seriously.

Conscientiously do a good job and perform technical operation crusher equipment maintenance is an important part of the work. Because the technical operation from production practice, the objective situation of the device, add the constant changes worked out. Proved, the more violations of operating procedures, crusher equipment accidents have on the more. So stick to technical operation has become a major long-term and regular work. Crusher of technical operations, the general must be the following methods:

Preparation before starting work:
(1) to check the oil pump, oil pump switch is closed, so the oil return pipe back to normal, in order to activate the crusher.
(3) Checking the oil tank, oil return pipe shall not be less than 50-100 mm, immediately fill the fuel shortage.
(4) Check the motor foot screws, all screws are loose.
(5) adjust the port of discharge, to ensure that specifications of discharge.
Crusher operation must note the following:

(1) pay attention to check oil and oil temperature, oil is not enough time fill, the temperature does not exceed 60 ℃.
(2) pay attention to listen to the crusher operation sound is normal, if different sound, stop immediately check and report foreman, team leader.
(3) operation, pay attention to check the ministries screws, the motor current is normal, found defective a timely manner.
(4) experienced a sudden power outage, the high-voltage switch off, and to resist the device handle before starting to move the location.

(5) to the miners and to see the belt should always keep within the drill head to remove the ore, iron and other alloy steel material, so as not to choke card bad iron crusher.
(6) Oil cylinder head must be kept clean, tight, to avoid falling into dust, dirty fuel oil can not be supplemented, at regular intervals, dirty oil, you have to be replaced.

In the parking, have to turn the ore crushing machine clean and in order to cut off the high voltage switch, and to resist the device handle before starting to move the location.

Jaw Crusher

Stone Crusher
http://www.china-xingbang.com

check the oil pump     crusher equipment     maintenance