Jaw crusher instructions

FOR IMMEDIATE RELEASE
(Free-Press-Release.com) February 11, 2012 -- Henan prospecting mandibles crusher instructions
(a) jaw crusher preparation before starting to work
1, carefully check bearing whether good lubrication, bearings inside cubits board is there enough joint grease.
2, carefully check all the fastening pieces are fully tighten.Sand maker
3, protective device are good,Ore separating line unsafe phenomenon, shall be immediately eliminate.
4, check the broken cavity or other sundry without ore, if have, shall be immediately eliminate.
(2) jaw crusher of starting

1,Ore separating line through inspection, prove machine and transmission part of the normal situation, only starting.
2, the machine can only in no load cases starting.
3, startup, if discover the abnormal situation,Sand maker should stop immediately, to clarify the cause eliminate hidden dangers, before starting again.
(3) jaw crusher maintenance and use
1 normal operation,Sand maker crusher, and then feed.
2, stay broken material should be evenly to join broken cavity, and should avoid side charging,China spiral classifier avoid load mutation or unilateral sudden increase.

3, in normal working circumstances, the rise of temperature of the bearing should not be more than 30 ℃, the highest temperature should not be more than 70 ℃, or should be to stop immediately, find out the reason to eliminate them.
4, before parking, should first stop charging,China spiral classifier wait for crushing cavity in broken material completely empty, and then close the motor.
5, when use, if by crushing cavity caused by blocked material to shut down, should immediately shut off the motor, the material must be ruled out before any use.
6, jaw plate end after wear turn use.


Rotary kiln：www.china-crusher.com/rotary-kiln5.html
Rotary kiln：www.china-crusher.com/rotary-kiln5.html
Vibratory feeder：www.hxjqcrusher.com/crusher/China-vibrating-feeder.html