Jaw Crusher Operation Instruction

FOR IMMEDIATE RELEASE
(Free-Press-Release.com) January 10, 2012 -- (1) jaw crusher preparation before starting to work
1, carefully check bearing whether good lubrication, bearings inside cubits board is there enough joint grease.
2, Mobile jaw crusher carefully check all the fastening pieces are fully tighten.
3, protective device are good, unsafe phenomenon, shall be immediately eliminate.
4, check the broken cavity or other sundry without ore, Impact crushing machine if have, shall be immediately eliminate.
(1)   jaw crusher of starting

1, through inspection, prove machine and transmission part of the normal situation, only starting
2, the machine can only in no load cases starting.
3, startup, Cone crusher if discover the abnormal situation, should stop immediately, to clarify the cause eliminate hidden dangers, before starting again.
(3) jaw crusher maintenance and use
1 normal operation, crusher, and then feed.
2, raymond mill stay broken material should be evenly to join broken cavity, and should avoid side charging, avoid load mutation or unilateral sudden increase.

3, in normal working circumstances, the rise of temperature of the bearing should not be more than 35 ℃, Impact crusher for sale the highest temperature should not be more than 70 ℃, or should be to stop immediately, find out the reason to eliminate them.
4, before parking, should first stop charging, wait for crushing cavity in broken material completely empty, and then close the motor.
5, Mobile crusher when use, if by crushing cavity caused by blocked material to shut down, should immediately shut off the motor, the material must be ruled out before any use.
6, jaw plate end after wear turn use.
(4) jaw crusher lubrication
1, often note completes promptly the lubrication friction work, Primary crushers can guarantee the normal operation of the machine and to extend the service life.

2, the machine adopts the grease, should be based on the use of sites, temperature, etc conditions to decide, general but with calcium and sodium, calcium and manufactured bases or sodium.
   3, join of the bearing grease for its volume of the 50-70%, every three months must be replaced one time. Change new oil must use clean gasoline or kerosene cleaning the self-contained bearing in the dirt.
4, elbow board and cubits in machines on board mat contact before, must join grease.
Jaw crusher maintenance rules and maintenance
Jaw crusher maintenance, no matter what the machine maintenance is very important
Single toggle jaw crusher ： www.china-crusher.com/product.html

China sand washers ： www.china-crusher.com/sand-washer3.html
Cement mill ： www.hxjqcrusher.com/Cement-mill.html