Plasma LED Lights for Automobiles

FOR IMMEDIATE RELEASE
(Free-Press-Release.com) April 6, 2011 -- Economic automobiles use less fuel for running. Fuel is valuable and may get exhausted in near future if what the scientists predict is correct. Starter motors and lighting systems consume energy. If this energy consumption can be reduced to the minimum economy of fuel consumption also can be achieved. That is why Plasma LED Lights are most valuable in automobile lighting.

Bulbs configured using 18 highly efficient LED lights are available in pairs. According to the type and make of vehicle the bulbs can be chosen. Bulbs are available in red, blue, while and amber colors. Color is to be selected according to the color of lenses fitted.

Motor cycle lights which are not a burden on battery can light it well. LED Pods with heat resistant sheathing can be used all over the motorcycle or car. Kit is available to run these lights with wireless switch also.

LED Tubes which are not power hungry can be used in cars. There are 12 LEDs in each tube. Tubes work on 12 volts battery of the car or with an adaptor at home. Twin Tubes 8 inch activated by sound run on car battery. These bright tubes create a great environment inside the car.

Under the car kit in sizes of 36 and 48 inch are powered by 12 volts battery. Using 378 bright LEDs can be controlled remotely also. They can be used at home with an adaptor. Tubes are flexible to some extent. Neon lamps previously used were fragile. Now the cost effective solution for under car lighting is gaining wide acceptance.

LED switches are fitted in the car. Dimmer switches can dim other LED lights to the desired level of brightness.

Turning signals in the car may flash wildly when replaced by LEDs. Turning lights are controlled by the computer of the car. LED lights consume very less power. So computer thinks that they re not there or not on. This is the reason for LED turning signals for flashing wildly. Adding resistors to the signal will solve the problem. But this will consume more power. Till car computers are redesigned this can be the solution.

Motor cycle lights can be replaces with LED lamps. Dimmer switch can be introduced Wireless switch can take the place of normal switches. While wiring LEDs in motor cycle make sure that the wires are not touching hot surfaces.

Normal LEDs run on 2 to 4 volts while automobiles use 12 volts batteries. Modification of the LEDs adding resistance in series is necessary. LEDs can be wired in series also. LEDs with pre-connected resistances can save lot of effort and time. More over the modules will give a better look also. Plasma LED Lights are available ready to be used with 9 volts or 12 volts batteries as required. Ac/dc converters with 12 volts adapters make it possible to connect bulbs or tubes configured with power saving LEDs to be connected directly to the conventional holders. Changing all the fittings in the house or car may neutralize benefits gained by use of LEDs due to added initial costs. Initial costs of replacing conventional bulbs with Plasma LED Lights will be cost effective as less energy charges will be there due to low energy consumption of the lights.

More information can be found online at http://www.plasmaled.com