Torsion Spring Design | Torsion Springs | Spring manufacturers

FOR IMMEDIATE RELEASE
Houston, Texas, United States of America (Free-Press-Release.com) October 20, 2011 -- www.katyspring.com

Please send inquiries to: sales@katyspring.com
Attn: Mark West Ph. 281-391-1888

Torsion Spring Design

All torsion springs exert torsion spring force along a circular path. Torsion springs are subject to bending stresses.
Torsion springs come in different forms such as clock springs and power springs, used in lawn mower cranks for example.
Mostly, torsion springs are helical springs made with round wire, square or rectangular wire loaded by torque or a twisting motion.

When designing torsion springs, the designer must consider the end configurations of the torsion spring, such as straight legs, loops, or multiple bends. The fewer the bends in a torsion spring, the greater the cost savings.
It’s also important to call out the wind direction in a torsion spring, because the torsion spring is typically wound with the legs going inward.
The material type of a torsion spring is important only if the torsion spring will be in extreme temperature or corrosive conditions. The spring manufacturer can help in torsion spring material selection and size to achieve the desired forces.

If possible, the desired torsion spring load should be specified in inch-pounds at the loaded position. The torsion spring leg angles relative to the torsion spring ends (loaded) and the angular relation of the ends when the torsion spring is in its free position. The torsion spring travel is the degrees beyond the loaded position.
Typically, torsion springs are manufactured with closed coils. In some cases, torsion springs have pitch or space between coils when the torsion spring is deflected.
Appropriate clearance should also be maintained in reference to the torsion spring’s body length. Spring manufactures can make recommendations for torsion spring body length clearance.
A torsion spring should always be loaded in the direction that decreases torsion spring outside diameter. In other words, the ends of the torsion spring are bending inwards.

Given that there is zero friction, the rate of a torsion spring is constant throughout its entire range of deflection. If too much friction causes the rate to vary, coil spacing may be necessary in the torsion spring. Torsion springs can be difficult to test because of friction and should be considered in a torsion spring design.
Torsion spring wire is stressed when it is bent. If the torsion spring wind direction increases the torsion spring diameter, the torsion spring can set unless it is properly stress relieved. Heating and/or shot peening will aid in preventing torsion spring residual stresses. The spring manufacturer can help with choosing the right stress relieve method.
Square or rectangular torsion springs are used in high stress conditions or when heavy load in required in a small space. Round wire is preferred because it’s more readily available and less expensive to manufacture.

A torsion spring increases in body length by one wire size for each revolution of the torsion spring. Torsion springs typically fit over a shaft to prevent the torsion spring from buckling. The torsion spring shaft should be about 20% of the torsion spring’s ID at fully loaded position.

www.katyspring.com

Please send inquiries to: sales@katyspring.com
Attn: Mark West Ph. 281-391-1888

katy spring     local spring manufacturers     spring manufacturer     spring manufacturers uk     torsion spring     Torsion Spring Design