Using problems of automatic vehicle

FOR IMMEDIATE RELEASE
(Free-Press-Release.com) April 20, 2011 -- Used in automatic car, some car owners lack of knowledge of the automatic transmission, follow the method of operation manual transmission automatic car driving, resulting in vehicle damage, vehicle performance degradation, shortened life expectancy. Here to talk about the type of vehicle automatic common errors, for reference.

1, high-speed driving, or linked to N gear when going downhill slide

Some drivers for fuel, or downhill at high speed, it will be appropriated for N gear shift lever (neutral) slide, which is likely to burn transmission. Because at this time a high transmission output shaft speed, and idle the engine, transmission, fuel supply enough lubrication deterioration, but also within the multi-plate clutch transmission, although the power has been cut off, but the passive film at high speed, driven wheel operation, and slipping easily lead to the phenomenon of resonance, resulting in adverse consequences. Do need a long downhill slide the moment when the shift lever can be maintained in the D block slide, but not the engine flameout.

2, a long block when parking was still hanging D

Automatic transmission equipped vehicles in traffic jams, some owners often only depresses the brake pedal, shift lever has remained in the D block (road block) does not shift. If time is short, this is permitted. However, if parking is best for a long time into the N block (neutral), and pull the handbrake. Because the shift lever in the D block, automatic transmission cars generally have weak forward, slam the brake pedal if the time is equal to forcibly stop this forward, making the transmission oil temperature rise, oil perishable, especially in air-conditioning system work, the higher the engine idling more unfavorable circumstances.

3, P or N in the starter motor gear other than

Some pilots in the P block or gear other than N start the engine block, although the engine can not run (because of chain protection, can only block in the P and N to start), but it may burn out the transmission neutral start switch. Because the automatic transmission is equipped with a neutral start switch. Makes the transmission block only in P or N to start the engine, to avoid errors in the other gears at once when starting the vehicle forward and started channeling. Therefore, before starting the engine and shift lever must be confirmed whether the P or N block.

4, start the engine cart

Equipped with automatic transmission and automotive catalytic converters can not start due to battery power shortage, and pushed or other vehicles using the method of dragging the start is very wrong. Because, using the above method is not the power delivered to the engine, it will damage the catalytic converter.

5, increase the throttle you can switch to high gear

Some drivers think that as long as the D block start, has stepped on the gas can change into high gear, not knowing that this is wrong. Because the shift operation should be "revenue in advance Shengdang throttle, step on the gas ahead of lower gear." That is, after starting in the D block, 5% throttle opening to maintain speed up to 40km / h, fast loose throttle, can increase to a gear, then accelerate to 75km / h, but also improve a loose throttle gear. Is reduced by the speed of vehicles, a little step on the gas, that is, back to low gear. It must be noted, can not step on the accelerator in the end. Otherwise, it will be forced into low gear hanging, may cause transmission damage.

【www.global-battery.co.uk】
A excellent cheap replacement batteries source: Save more than 30%!

Dell Inspiron 1545 battery
http://www.global-battery.co.uk/laptop-batteries/dell-inspiron-1545.htm
CANON PowerShot SD790 IS battery
http://www.global-battery.co.uk/digital-camera-batteries/canon-powershot-sd790-is.htm
CANON nb-7l battery
http://www.global-battery.co.uk/digital-camera-batteries/canon-nb-7l.htm

automatic vehicle     repair tips